๐Ÿ”ฅ Pool Heater Repair & Service

Pool heater repair in Hartland, WI. Gas heaters, heat pumps, and electric heaters. Diagnosis, repair, and replacement. Serving Lake Country. Call (262) 367-8281.

Get Your Heater Running Again

A pool heater that will not fire or maintain temperature cuts your swimming season short. We diagnose and repair all heater types โ€” gas, heat pump, and electric โ€” for residential pools across Lake Country.

Gas Heater Service

Ignition system diagnosis, burner tray cleaning (spider nests are the number one cause of failure after winter), heat exchanger inspection, gas valve testing, and control board troubleshooting. We service Raypak, Hayward, Pentair, and all major brands.

Heat Pump Service

Refrigerant system diagnosis, evaporator coil cleaning, fan motor repair, defrost cycle troubleshooting, and compressor evaluation. Heat pumps are the most energy-efficient option but require specialized knowledge to service properly.

Wisconsin-Specific Advice

Our short swimming season means your heater works harder in a compressed timeframe. We recommend testing your heater during spring opening โ€” not the first warm weekend โ€” so there is time to address issues before you need it.

Pro Tip: If your gas heater fires but shuts off after a few minutes, check your filter pressure first. Most heaters have a high-limit switch that trips when water flow is restricted by a dirty filter. A simple backwash might be all you need.

New Rheem natural gas pool heater installed by Heartland Pool and Spa in Hartland WI

From No-Heat Calls to Full Installs

This Rheem went in on one of our service calls โ€” sized right for the pool, plumbed clean, and fired the same day. Whether your heater needs an igniter, a sensor, or a dignified retirement, we handle gas heaters, heat pumps, and electric units across Lake Country.

In a Wisconsin season that is short enough already, a dead heater costs you real swim weeks. We prioritize no-heat calls accordingly.

  • Rheem, Raypak, Hayward, Pentair, and more
  • Ignition, sensor, gas valve, and control board repairs
  • Full replacement installs, sized for your pool and our climate
Request Service
How It Works

Getting Your Heat Back

1
Diagnose the Fault
Error codes, gas supply, ignition sequence, flow switch โ€” we find the actual fault, not the first guess.
2
Repair or Replace โ€” Honestly
A cracked heat exchanger on a 12-year-old unit is a replacement. A $90 sensor is not. We tell you which is which.
3
Fix It Right
OEM parts, proper gas pressures, clean burner tray. Heaters are not the place for improvisation.
4
Fire Up & Verify
Full heat cycle, temperature rise measured, safeties tested before we leave.
Common Questions

Good to Know

If the heat exchanger is cracked or the unit is past 10-12 years, replacement usually wins on math alone. For igniters, sensors, boards, and gas valves on younger units, repair is the smart money.
Bigger than the same pool would need down south โ€” our springs and falls are cold. As a rough guide, most Lake Country in-ground pools land between 200k and 400k BTU. We size it properly from your pool volume and how you use it.
Most often a flow problem โ€” dirty filter, low water level, or a failing pressure switch โ€” rather than the heater itself. It is also the cheapest category of fix, so do not assume the worst.
Service Coverage

Serving All of Lake Country

Ready for Crystal Clear?

Call us, stop by with a water sample, or send a message. We make it easy.